Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 331)

Unified IP MIB Reference 303
53-1002549-02
VLAN by IP subnet configuration table
VLAN by IP subnet configuration table
The following table applies to protocol VLANs that use the IP routing protocol.
snVLanByProtocolRowStatus
brcdIp.1.1.3.2.2.1.7
Syntax: Integer Read-write Controls the management of the table rows. The following values can
be written:
•
delete(3) – Deletes the row.
•
create(4) – Creates a new row.
•
modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
invalid(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
snVLanByProtocolDynamicM
ask
brcdIp.1.1.3.2.2.1.8
Syntax: PortMask Read-only Shows the portmask, which is the standalone switch Protocol VLAN
active port membership.
This object was obsoleted.
snVLanByProtocolChassisSta
ticMask
brcdIp.1.1.3.2.2.1.9
Syntax: OCTET STRING Read-write This object has 32 octets. It has been obsoleted and replaced by the
“snVLanByProtocolStaticPortList” object.
snVLanByProtocolChassisExc
ludeMask
brcdIp.1.1.3.2.2.1.10
Syntax: OCTET STRING Read-write This object has 32 octets. It has been obsoleted and replaced by the
“snVLanByProtocolExcludePortList” object.
snVLanByProtocolChassisDy
namicMask
brcdIp.1.1.3.2.2.1.11
Syntax: OCTET STRING Read-write This object has 32 octets. It has been obsoleted and replaced by the
“snVLanByProtocolDynamicPortList” object.
snVLanByProtocolVLanName
brcdIp.1.1.3.2.2.1.12
Syntax: DisplayString Read-write Shows the name of the community string that is allowed to access
the VLAN.
Valid values: Up to 32 characters
snVLanByProtocolStaticPortL
ist
brcdIp.1.1.3.2.2.1.13
Syntax: OCTET STRING Read-write This object is an index of ports that are configured to be members of
the Protocol VLAN. Each port index is a 16-bit integer in big-endian
order. The first 8 bits are the slot number; the other 8 bits are the
port number.
snVLanByProtocolExcludePor
tList
brcdIp.1.1.3.2.2.1.14
Syntax: OCTET STRING Read-write This object is an index of ports that are excluded from port
membership of the Protocol VLAN. Each port index is a 16-bit integer
in big-endian order. The first 8 bits are the slot number; the other 8
bits are the port number.
snVLanByProtocolDynamicP
ortList
brcdIp.1.1.3.2.2.1.15
Syntax: OCTET STRING Read-only This object is an index of ports that can dynamically join the port
membership of the Protocol VLAN. Each port index is a 16-bit integer
in big-endian order. The first 8 its are the slot number; the other 8
bits are the port number.
Name, OID, and syntax Access Description