Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 735)

Unified IP MIB Reference 707
53-1002549-02
Proprietary traps
MPLS LSP notification
The following traps are generated for the MPLS LSP feature supported only on the Brocade NetIron
MLX, Brocade MLXe, Brocade NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series
devices.
NOTE
Do not use the following traps if you are using the snTrapTMLogging traps.
MPLS LSR notification
The following traps are generated for the MPLS LSR feature supported only on the Brocade NetIron
MLX, Brocade MLXe, Brocade NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series
devices.
Enable the mplsXCNotificationsEnable (OID 1.3.6.1.2.1.10.166.2.1.15 ) object to true(1) to
generate mplsXCUp and mplsXCDown notifications. Use the lsp-xc-traps enable command to
enable or disable the MPLS cross-connect traps and syslog messages. The show mpls config
command displays the status of the LSP XC notifications.
fdryVplsDeleted
brcdIp.1.2.15.2.0.2 vplsConfigName
fdryVplsVcId Informational An entry in the fdryVplsTable has been marked
for deletion. It indicates the deletion of an
existing VPLS instance.
fdryPwCreated
brcdIp.1.2.15.2.0.3 fdryPwServiceType
(vll(1), vlllocal(2),
vpls(3))
pwName (The
instance name)
pwID (VD ID) Informational Generated when an instance of VLL or VLL-Local
pseudo-wire entry is created in the pwTable. The
fdryPwServiceType varbind shows the service
type that originated this notification.
This notification is not used for VPLS service.
This notification is not generated during device
bootup.
Trap name and number Varbinds Severity Description
snMplsLspUp
brcdIp.0.1010 mplsLspName,
mplsPathName Informational Specifies the LSP is up. The current active path
for the LSP is the value of mplsPathName.
snMplsLspDown
brcdIp.0.1011 mplsLspName,
mplsPathName Informational Specifies the LSP is down, because the current
active path specified by the mplsPathName
went down.
snMplsLspChange
brcdIp.0.1012 mplsLspName,
mplsPathName Informational Specifies the particular LSP that has switched
traffic to the new active path ”toLspPath”. The
LSP maintains an up state before and after the
switchover.
Trap name and number Varbinds Severity Description