Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 520)

492 Unified IP MIB Reference
53-1002549-02
BGP4 route map filter table
BGP4 route map filter table
A route map is a named set of match conditions and parameter settings that a Layer 3 Switch can
use to modify route attributes and to control redistribution of routes.
BGP4 allows you to include the redistribution filters as part of a route map. A route map examines
and modifies route information exchanged between BGP4 and RIP or OSPF.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
snBgp4RedisWeight
brcdIp.1.2.11.11.1.1.4
Syntax: Integer Read-write Specifies the weight assigned to this entry.
snBgp4RedisMatchInternal
brcdIp.1.2.11.11.1.1.5
Syntax: Integer Read-write Applies only to the OSPF protocol:
•
disabled(0)
•
enabled(1)
snBgp4RedisMatchExternal1
brcdIp.1.2.11.11.1.1.6
Syntax: Integer Read-write Applies only to the OSPF protocol:
•
disabled(0)
•
enabled(1)
snBgp4RedisMatchExternal2
brcdIp.1.2.11.11.1.1.7
Syntax: Integer Read-write Applies only to the OSPF protocol:
•
disabled(0)
•
enabled(1)
snBgp4RedisRowStatus
brcdIp.1.2.11.11.1.1.8
Syntax: Integer Read-write Controls the management of the table rows. The following
values can be written:
•
delete(3) – Deletes the row.
•
create(4) – Creates a new row.
•
modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
invalid(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snBgp4RouteMapFilterTable
brcdIp.1.2.11.12.1 None The BGP4 route map filter table.
snBgp4RouteMapFilterMapName
brcdIp.1.2.11.12.1.1.1
Syntax: OCTET STRING Read-only Shows the route map’s name.
The value of this object contains an octet string. Each
character is represented by one octet. There can be up to
32 octets in this object.
snBgp4RouteMapFilterSequenceNum
brcdIp.1.2.11.12.1.1.2
Syntax: Integer32 Read-only Shows the sequence number for this particular route map.