Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 456)

428 Unified IP MIB Reference
53-1002549-02
MCT cluster client table
MCT cluster client table
The following table lists the MCT cluster client MIB objects. The deploy command or SNMP SET
request for the brcdMctClusterClientDeploy object with the deploy(2) value verifies if the
configuration is set properly or not. The notReady(3) enum value for the
brcdMctClusterClientRowStatus object indicates not all the required cluster client configuration
objects are configured.
brcdMctClusterPeerUpTime
brcdIp.1.1.12.1.1.4.1.11
Syntax: TimeInterval Read-only The time since the MCT cluster peer is up and running. If the
brcdMctClusterPeerOperStatus object is not in the ccpUp(2)
state, then the value 0 is returned.
brcdMctClusterPeerRowStatus
brcdIp.1.1.12.1.1.4.1.12
Syntax: RowStatus Read-create The row status of the MCT cluster peer. Only the active(1),
notInService(2), createAndGo(4), and destroy(6) values of the
RowStatus are supported. The notInService(2) value indicates
the cluster is not yet activated.
The SNMP SET request to create a row with the
brcdMctClusterPeerRowStatus object set to the createAndGo(4)
value must contain the brcdMctClusterPeerRbridgeId and
brcdMctClusterPeerIclName objects in the same SNMP SET
request.
If the cluster is deployed, then the
brcdMctClusterPeerRowStatus object cannot be set to
destroy(6).
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
brcdMctClusterClientTable
brcdIp.1.1.12.1.1.5 None The MCT cluster client table.
brcdMctClusterClientName
brcdIp.1.1.12.1.1.5.1.1
Syntax: DisplayString None The name of the MCT cluster client.
brcdMctClusterClientRbridg
eId
brcdIp.1.1.12.1.1.5.1.2
Syntax: Unsigned32 Read-create The remote bridge ID of the MCT cluster client. The remote bridge ID
is used by the client to communicate with the cluster node.
Valid values: 1 - 35535
brcdMctClusterClientIfIndex
brcdIp.1.1.12.1.1.5.1.3
Syntax: InterfaceIndex Read-create The interface index that is connected to the MCT cluster client. The
interface must be an Ethernet interface or trunk interface.