Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 557)

Unified IP MIB Reference 529
53-1002549-02
OSPF virtual interface status table
OSPF virtual interface status table
The OSPF virtual interface status table contains information about this router’s virtual interfaces.
Reference: RFC 1583 “OSPF Version 2”, section C.4 Virtual link parameters.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron XMR, Brocade
NetIron MLX, Brocade NetIron CES, and Brocade NetIron CER series devices.
snOspfIfStatusMd5Activation
WaitTime
brcdIp.1.2.4.12.1.1.21
Syntax: Integer Read-only Determines when a newly configured MD5 authentication key is
valid. This parameter provides a graceful transition from one MD5
key to another without disturbing the network. All new packets
transmitted after the key activation wait time interval use the newly
configured MD5 key. OSPF packets that contain the old MD5 key are
accepted for up to five minutes after the new MD5 key is in operation.
The range for the key activation wait time is from 0 through 14400
seconds.
snOspfIfStatusAreaIdFormat
brcdIp.1.2.4.12.1.1.22
Syntax: Integer Read-only Specifies the format of how Area ID will be entered in the
“snOspfIfStatusAreaId” object:
•
integer(0) – Integer.
•
ipAddress(1) – IP address
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snOspfVirtIfStatusTable
brcdIp.1.2.4.13.1 None The OSPF virtual interface status table.
snOspfVirtIfStatusEntryInde
x
brcdIp.1.2.4.13.1.1.1
Syntax: Integer32 Read-only The ID of the entry in this table.
snOspfVirtIfStatusAreaID
brcdIp.1.2.4.13.1.1.2
Syntax: AreaID Read-only Shows the ID of the transit area that the virtual link traverses. The
value of this object cannot be 0.0.0.0. The format of this object is
determined by the value of the
“snOspfVirtIfStatusAreaIdFormat”
object.
snOspfVirtIfStatusNeighbor
brcdIp.1.2.4.13.1.1.3
Syntax: RouterID Read-only Shows the ID or IP address of the router that is serving as the virtual
neighbor.
snOspfVirtIfStatusTransitDel
ay
brcdIp.1.2.4.13.1.1.4
Syntax: UpToMaxAge Read-only Shows the time it takes to transmit link-state update packets on this
interface.
Valid values: 0 – 3600 seconds
Default: 1 second
snOspfVirtIfStatusRetransIn
terval
brcdIp.1.2.4.13.1.1.5
Syntax: UpToMaxAge Read-only Specifies the interval between the retransmission of link-state
advertisements to router adjacencies for this interface.
Valid values: 0 – 3600 seconds
Default: 5 seconds