Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 724)

696 Unified IP MIB Reference
53-1002549-02
Proprietary traps
snOspfNbrStateChange
1.3.6.1.2.1.14.16.2.5 snOspfRouterId (The
originator of the trap)
snOspfNbrIpAddr
snOspfNbrRtrId
snOspfNbrState (The
new state) Informational There has been a change in the state of a
non-virtual OSPF neighbor. This trap
should be generated when a neighbor
state regresses (for example, goes from
Attempt or Full to 1-Way or Down) or
progresses to a terminal state (for
example, 2-Way or Full). When an neighbor
transitions from or to Full on
non-broadcast multi-access and broadcast
networks, the trap should be generated by
the designated router. A designated router
transitioning to Down will be noted by
ospfIfStateChange.
NOTE: You must configure the log
adjacency command under the
"router ospf" mode to see traps.
Sample trap message:
OSPF router id
<snOspfRouterId> neighbor area
<snOspfNbrIpAddr>,neighbor
router id <snOspfNbrRtrId>
state changed to
<snOspfNbrState>.
snOspfVirtNbrStateChang
e
1.3.6.1.2.1.14.16.2.6 snOspfRouterId (The
originator of the trap)
snOspfVirtNbrArea
snOspfVirtNbrRtrId
snOspfVirtNbrState
(The new state) Informational There has been a change in the state of an
OSPF virtual neighbor. This trap should be
generated when the neighbor state
regresses (for example, goes from Attempt
or Full to 1-Way or Down) or progresses to
a terminal state (for example, Full).
NOTE: You must configure the log
adjacency command under the
"router ospf" mode to see traps.
Sample trap message:
OSPF router id
<snOspfRouterId> virtual
neighbor area
<snOspfVirtNbrArea>, virtual
neighbor router id
<snOspfVirtNbrRtrId> state
changed to
<snOspfVirtNbrState>.
Trap name and number Varbinds Severity Description and trap message