Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 583)

Unified IP MIB Reference 555
53-1002549-02
Chapter
54
FSRP MIB Definition
In this chapter
• FSRP objects . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 555
• FSRP global variables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 555
• FSRP interface table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 556
FSRP objects
The Foundry Standby Routing Protocol (FSRP) allows alternate paths to be provided to a host. To
provide path redundancy between given hosts, a virtual router is created. To create a virtual router,
unique IP addresses are assigned to ports on existing routers in the network routers that could
provide a path between the given hosts.
This chapter presents the objects for FSRP. You must determine if your device supports FSRP
before using the MIB objects for FSRP traps.
NOTE
The FSRP MIBs are not supported on the Brocade NetIron MLX, Brocade MLXe, Brocade NetIron
XMR, Brocade NetIron CES, Brocade NetIron CER series, and Brocade FastIron devices.
FSRP global variables
The following MIB objects apply to all FSRP interfaces.
Name, OID, and syntax Access Description
snFsrpGroupOperMode
brcdIp.1.2.7.1.1
Syntax: Integer Read-write Indicates if FSRP is enabled:
•
disabled(0)
•
enabled(1)
NOTE: Do not enable both FSRP and VRRP. It is recommended that
you use only one of these router redundancy protocols on a
Layer 3 Switch.
Default: disabled(0)
snFsrpIfStateChangeTrap
brcdIp.1.2.7.1.2
Syntax: Integer Read-write Indicates if the SNMP agent process has been enabled to generate
FSRP interface state change traps:
•
disabled(0)
•
enabled(1)
Default: enabled(1)