Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 691)

Unified IP MIB Reference 663
53-1002549-02
Virtual server history control group table
Virtual server history control group table
The virtual server history control group table contains objects that control the collection of data
samples for virtual servers.
snL4RealServerPortHistoryCurCo
nnections
brcdIp.1.1.4.28.4.1.7
Syntax: Integer Read-only Shows the number of client connections currently on the real
server. A connection consists of two sessions: the client-to-server
session and the server-to-client session.
snL4RealServerPortHistoryPeakC
onnections
brcdIp.1.1.4.28.4.1.8
Syntax: Integer Read-only Shows the highest number of client connections on the real
server. A connection consists of two sessions: the client-to-server
session and the server-to-client session.
snL4RealServerPortHistoryRespo
nseTime
brcdIp.1.1.4.28.4.1.9
Syntax: Integer Read-only Shows the round trip time for a response from a real server on
this port.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snL4VirtualServerHistoryControlTa
ble
brcdIp.1.1.4.28.5 None Virtual server history control group table.
snL4VirtualServerHistoryControlIn
dex
brcdIp.1.1.4.28.5.1.1
Syntax: Integer Read-only An index that uniquely identifies an entry in this table. Each
entry defines a set of samples at a particular interval for a
virtual server on the ServerIron. This object can have up to
65535 entries.
snL4VirtualServerHistoryControlDa
taSource
brcdIp.1.1.4.28.5.1.2
Syntax: Object Identifier Read-write This object identifies the source of the historical data that was
collected for this entry. The source can be any virtual server on
this ServerIron.
It identifies a particular instance defined in the
“snL4VirtualServerStatisticTable” .
It may not be modified if the value of the
“snL4VirtualServerHistoryControlStatus” object for this entry
source is equal to valid(1).
snL4VirtualServerHistoryControlBu
cketsRequested
brcdIp.1.1.4.28.5.1.3
Syntax: Integer Read-write Indicates the requested number of data samples that will be
saved for this entry. The number of samples saved in the
“snL4VirtualServerHistoryControlBucketsGranted” object
should be close to the value of this object. If the value of this
object is modified, then the value of the
“snL4VirtualServerHistoryControlBucketsGranted” object will
be adjusted according to the new value of this object.
Valid values: 1 – 65535
Default: 50