Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 661)

Unified IP MIB Reference 633
53-1002549-02
Hot standby
Name, OID, and syntax Access Description
snL4BackupInterface
brcdIp.1.1.4.1.14
Syntax: Integer Read-write Identifies which port is the hot standby port. This is the port that serves
as a private link between the active and the redundant ServerIrons. The
ServerIrons use this port to monitor any failover and to communicate
those events to the standby.
Valid values: 0 – 26
snL4BackupMacAddr
brcdIp.1.1.4.1.15
Syntax: Physical address Read-write Identifies the associated MAC address for the backup monitoring port.
The active and backup ServerIron must have the same MAC address.
snL4Active
brcdIp.1.1.4.1.16
Syntax: L4flag Read-only The “snL4Redundancy” object and this object are the same.
Indicates if this ServerIron has been configured as redundant or hot
standby:
•
false(0) – This ServerIron is the active one.
•
true(1) – This ServerIron is the standby.
snL4Redundancy
brcdIp.1.1.4.1.17
Syntax: Integer Read-only The “snL4Active” object and this object are the same.
Indicates if this ServerIron has been configured as redundant or hot
standby:
•
false(0) – This ServerIron is the active one.
•
true(1) – This ServerIron is the standby.
snL4Backup
brcdIp.1.1.4.1.18
Syntax: L4flag Read-only Indicates if the ServerIron is the backup (standby) ServerIron:
•
false(0) – This ServerIron is the active one.
•
true(1) – This ServerIron is the standby.
snL4BecomeActive
brcdIp.1.1.4.1.19
Syntax: Integer Read-only Shows the number of times this ServerIron has changed from standby
to active.
snL4BecomeStandBy
brcdIp.1.1.4.1.20
Syntax: Integer Read-only Shows the number of times this ServerIron has changed from active to
standby.
snL4BackupState
brcdIp.1.1.4.1.21
Syntax: Integer Read-only Shows the state of the backup or redundancy link of the active or
standby ServerIron:
•
slbSyncComplete(0) – Synchronization is complete.
•
slbSyncReqMap(1) – Port map has been synchronized.
•
slbSyncreqMac(2) – MAC addresses have been synchronized.
•
slbSyncreqServers(3) – Server information has been synchronized.
•
slbSyncReqL4(4) – L4 packets have been synchronized.
snL4NoPDUSent
brcdIp.1.1.4.1.22
Syntax: Integer
NOTE: This object is not
supported.
Read-only The number of Layer 4 or MAC-layer PDUs sent.
snL4NoPDUCount
brcdIp.1.1.4.1.23
Syntax: Integer Read-only The number of missed Layer 4 or MAC-layer PDUs.
snL4NoPortMap
brcdIp.1.1.4.1.24
Syntax: Integer Read-only Shows the number of missed port map PDUs, which are PDUs used by
ServerIron to discover information about the maps on the other
ServerIron.