Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 282)

254 Unified IP MIB Reference
53-1002549-02
Packet port information table
snPOSInfoSpeed
brcdIp.1.2.14.1.1.1.5
Syntax: Integer Read-write The bandwidth of the interface, which can be one of the following:
•
s155000(1) bps
•
s622000(2) bps
•
other(3)
•
s2488000(4) bps
snPOSInfoAdminStatus
brcdIp.1.2.14.1.1.1.6
Syntax: Integer Read-write The desired state of the interface, which can be one of the
following:
•
up(1) – The port is ready to pass packets.
•
down(2) – The port is not ready to pass packets.
•
testing(3) – The port is in test mode. No packets can be
passed.
snPOSInfoLinkStatus
brcdIp.1.2.14.1.1.1.7
Syntax: Integer Read-only The current operational state of the link, which can be one of the
following:
•
up(1) – The port is ready to pass packets.
•
down(2) – The port is not ready to pass packets.
•
testing(3) – The port is in test mode. No packets can be
passed.
snPOSInfoClock
brcdIp.1.2.14.1.1.1.8
Syntax: Integer Read-write The clock source, which can be one of the following:
•
internal(1) – The interface is using the clock on the POS
module.
•
line(2) – The interface is using the clock source supplied on
the network.
Default: internal(1)
snPOSInfoLoopBack
brcdIp.1.2.14.1.1.1.9
Syntax: Integer Read-write The loopback state of the interface. The loopback state can be one
of the following:
•
line(1) – The loopback path consists of both this POS interface
and the POS interface at the remote end of the link. Use this
mode to check the POS interface along the link.
•
internal(2) – The loopback path consists only of the POS
circuitry on this interface. Use this mode to check the POS
circuitry.
•
none(3) – The interface is not operating in loopback mode.
snPOSInfoScrambleATM
brcdIp.1.2.14.1.1.1.10
Syntax: Integer Read-write The state of the ATM scramble mode, which can be one of the
following:
•
disabled(0) – Scrambling is disabled.
•
enabled(1) – Scrambling of the Synchronous Payload Envelope
(SPE) is enabled. Data in the SONET packet is scrambled for
security.
Default: disabled(0)
snPOSInfoFraming
brcdIp.1.2.14.1.1.1.11
Syntax: Integer Read-write The frame type used on the interface. The frame type can be one of
the following:
•
sonet(1) – Synchronous Optical Network.
•
sdh(2) – Synchronous Digital Hierarchy.
Default: sonet(1)
snPOSInfoCRC
brcdIp.1.2.14.1.1.1.12
Syntax: Integer Read-write The length of the CRC field in packets transmitted on the interface.
The length can be one of the following:
•
crc32bits(1) – The field is 8 bits long.
•
crc16bits(2) – The field is 16 bits long.
Default: crc32bits(1)
Name, OID, and syntax Access Description