Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 423)

Unified IP MIB Reference 395
53-1002549-02
ACL bind to port table
ACL bind to port table
The ACL bind to port table contains ACL port bindings for a Layer 3 Switch. Port numbers and bind
direction are used to index entries.
NOTE
The ACL port MIBs are supported on the Brocade MLXe and Brocade NetIron XMR devices.
snAgAclIcmpCode
(continued) Valid value for type code 18, Address mask request
1 = Address mask request
Valid value for type code 19, Address mask reply
1 = Address mask reply
snAgAclParameters
brcdIp.1.2.2.15.2.1.31
Syntax: BITS Read-write The mask represents multiple parameters are configured
for the ACL. Bit 0 specifies the first octet.
•
Bit 0 = Matches fragmented IP packets.
•
Bit 1 = Matches non-fragmented IP packets.
•
Bit 2 = Matches only the TCP packets with SYN Bit
set. Valid only if the snAgAclSourceOperator or
snAgAclDestinationOperator object is set to TCP.
•
Bit 3 = Permits the packets that fail in RPF check.
•
Bit 4 = Mirrors the packets matching ACL permit
clause.
•
Bit 5 = Sends the packets matching ACL permit
clause to sFlow collector.
•
Bit 6 = Sets the dscp-mapping. The value is given by
snAgAclDscpMarking.
•
Bit 7 = Sets the dscp-marking. The value is given by
snAgAclDscpMapping.
snAgAclVlanId
brcdIp.1.2.2.15.2.1.32
Syntax: FdryVlanIdOrNoneTC Read-creat
e An optional VLAN ID to match against the incoming
packets. By default, the VLAN ID field is ignored during the
match and the value 0 is returned.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snAgAclIfBindTable
brcdIp.1.2.2.15.4 None The ACL bind to port table.
snAgAclIfBindIndex
brcdIp.1.2.2.15.4.1.1
Syntax: InterfaceIndex Read-only The number of the virtual or physical interface to which
this ACL is bound.
snAgAclIfBindDirection
brcdIp.1.2.2.15.4.1.2
Syntax: Direction Read-only Shows the traffic direction to which the ACL will be
applied:
•
inbound(0)
•
outbound(1)
snAgAclIfBindNum
brcdIp.1.2.2.15.4.1.3
Syntax: Integer Read-create Shows the defined IPv4 ACL number that will be bound to
the port.