Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 665)

Unified IP MIB Reference 637
53-1002549-02
Virtual server configuration table
Virtual server configuration table
The virtual server configuration table allows you to configure virtual servers on the ServerIron
devices.
snL4EnableGslbHealthCheckIpPor
tDownTrap
brcdIp.1.1.4.1.46
Syntax: Integer Read-write Indicates if this device has been enabled to generate traps
when an application port in a domain on the site IP address
fails its Layer 4 TCP or UDP health check, resulting in a status
change to down:
•
disabled(0)
•
enabled(1)
snL4EnableGslbRemoteGslbSiDo
wnTrap
brcdIp.1.1.4.1.47
Syntax: Integer Read-write Indicates if this device has been enabled to generate traps
when the connection from this site to the remote GSLB
ServerIron is down:
•
disabled(0)
•
enabled(1)
snL4EnableGslbRemoteGslbSiUpT
rap
brcdIp.1.1.4.1.48
Syntax: Integer Read-write Indicates if this device has been enabled to generate traps
when the connection from this site to the remote GSLB
ServerIron is up:
•
disabled(0)
•
enabled(1)
snL4EnableGslbRemoteSiDownTr
ap
brcdIp.1.1.4.1.49
Syntax: Integer Read-write Indicates if this device has been enabled to generate traps
when the GSLB connection from this GSLB ServerIron to the
remote ServerIron is down:
•
disabled(0)
•
enabled(1)
snL4EnableGslbRemoteSiUpTrap
brcdIp.1.1.4.1.50
Syntax: Integer Read-write Indicates if this device has been enabled to generate traps
when the GSLB connection from this GSLB ServerIron to remote
the ServerIron is up:
•
disabled(0)
•
enabled(1)
snL4slbRouterInterfacePortList
brcdIp.1.1.4.1.51
Syntax: OCTET STRING Read-write Shows the router interface port list. Each port index is a 16-bit
integer in big-endian order. The first 8 bits indicate the slot
number, the other 8 bits indicate the port number.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snL4VirtualServerCfgTable
brcdIp.1.1.4.21.1 None Virtual server configuration table.
snL4VirtualServerCfgVirtualIP
brcdIp.1.1.4.21.1.1.1
Syntax: IpAddress Read-only Specifies the virtual server IP address.
snL4VirtualServerCfgName
brcdIp.1.1.4.21.1.1.2
Syntax: L4ServerName Read-write Specifies the name of the virtual server. This name must be
unique among the other virtual servers.
Valid values: 1 – 32 octets