Vsrp mib definition, Global vsrp objects, Snvsrpgroupopermodevsrp – Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) User Manual

Page 459: Snvsrpifstatechangetrap, Snvsrpifmaxnumvridperintf, Chapter 44, Chapter

Advertising
background image

Unified IP MIB Reference

431

53-1002549-02

Chapter

44

VSRP MIB Definition

In this chapter

Global VSRP objects . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 431

VSRP interface table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 432

VSRP virtual router table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 432

The Virtual Switch Redundancy Protocol (VSRP) is a proprietary protocol that provides redundancy
and sub-second failover in Layer 2 and Layer 3 mesh topologies. Based on the Virtual Router
Redundancy Protocol Extended (VRRP-E), VSRP provides one or more backups for a Layer 2 Switch
or Layer 3 Switch. If the active Layer 2 Switch or Layer 3 Switch becomes unavailable, one of the
backups takes over as the active device and continues forwarding traffic for the network.

The MIB objects of the following sections are available for VSRP to provide SNMP support for VSRP
and these MIB objects are supported on the Brocade MLXe, Brocade NetIron MLX, Brocade NetIron
XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.

Global VSRP objects

The following table contains the global VSRP objects. Use the router vsrp and snmp-server enable
traps vsrp CLI commands for information on global VSRP objects.

NOTE

Only one of the virtual router protocols can be enabled at any one time.

Name, OID, and syntax

Access

Description

snVsrpGroupOperModeVsrp
brcdIp.1.1.3.21.1.1
Syntax: Integer

Read-write

Indicates if VSRP is enabled or disabled on this system:

disabled(0)

enabled(1)

Default: disabled(0)

snVsrpIfStateChangeTrap
brcdIp.1.1.3.21.1.2
Syntax: Integer

Read-write

Indicates whether the SNMP agent process is permitted to
generate VSRP interface state change traps:

disabled(0)

enabled(1)

Default: enabled(1)

snVsrpIfMaxNumVridPerIntf
brcdIp.1.1.3.21.1.3
Syntax: Integer32

Read-only

Indicates the maximum number of VRIDs that an interface can
have.

Advertising