Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 578)

550 Unified IP MIB Reference
53-1002549-02
DVMRP neighbor table
DVMRP neighbor table
The DVMRP neighbor table lists the router DVMRP neighbors, as discovered by the receiving
neighbor probe messages.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
snDvmrpVInterfaceRemoteSubnet
Mask
brcdIp.1.2.5.1.13.1.6
Syntax: IpAddress Read-only Shows the subnet mask for a directly connected subnet. For a
tunnel, this should be 0.0.0.0.
snDvmrpVInterfaceMetric
brcdIp.1.2.5.1.13.1.7
Syntax: Integer Read-write Defines the distance metric for this DVMRP virtual interface.
The router uses the metric when establishing reverse paths to
some networks on directly attached interfaces.
Valid values: 1 – 31 hops
Default: 1
snDvmrpVInterfaceTtlThreshold
brcdIp.1.2.5.1.13.1.8
Syntax: Integer Read-write Defines the minimum value required in a packet in order for
the packet to be forwarded out of the interface. For example, if
the TTL for an interface is set at 10, then only those packets
with a TTL value of 10 or more are forwarded. Likewise, if an
interface is configured with a TTL threshold value of 1, all
packets received on that interface are forwarded.
Valid values: 1 – 64
Default: 1
snDvmrpVInterfaceAdvertiseLocal
brcdIp.1.2.5.1.13.1.9
Syntax: Integer Read-write Determines if advertising of this local route is enabled:
•
disabled(0)
•
enabled(1)
Default: enabled(1)
snDvmrpVInterfaceEncapsulation
brcdIp.1.2.5.1.13.1.10
Syntax: Integer Read-write Indicates if the encapsulation of the DVMRP control packets
when using IPINIP encapsulation is enabled:
•
disabled(0)
•
enabled(1)
Default: disabled(0)
snDvmrpVInterfaceStatus
brcdIp.1.2.5.1.13.1.11
Syntax: Integer Read-write Controls the management of the table rows. The following
values can be written:
•
delete(3) – Deletes the row.
•
create(4) – Creates a new row.
•
modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
invalid(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
Name, OID, and syntax Access Description