Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 287)

Unified IP MIB Reference 259
53-1002549-02
POS PPP group
POS PPP group
If the snPOSInfo2Encapsulation object is set to Point to Point Protocol (PPP), the following table
provides information on the states of various control protocols.
snPOSInfo2OverheadJ1MessageL
ength
brcdIp.1.2.14.1.2.1.12
Syntax: Integer Read-write Overhead J1 length of message:
•
s16(16) - 16 bytes
•
s64(64) - 64 bytes
Default Value: s64(64)
snPOSInfo2OverheadJ1TransmitM
essage
brcdIp.1.2.14.1.2.1.13
Syntax: Octet String Read-write Overhead J1 transmit message.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snPOSPPPTable
brcdIp.1.2.14.1.3 None The POS PPP table.
snPOSPPP-LCP
brcdIp.1.2.14.1.3.1
Syntax: DisplayString Read-only The PPP link control protocol state.
snPOSPPP-IPCP
brcdIp.1.2.14.1.3.2
Syntax: DisplayString Read-only The PPP IP control protocol state.
snPOSPPP-IPv6CP
brcdIp.1.2.14.1.3.3
Syntax: DisplayString Read-only The PPP IPv6 control protocol state.
snPOSPPP-OSINLCP
brcdIp.1.2.14.1.3.4
Syntax: DisplayString Read-only The PPP OSI network layer control protocol state.
snPOSPPP-MPLSCP
brcdIp.1.2.14.1.3.5
Syntax: DisplayString Read-only The PPP MPLS control protocol state.