Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 487)

Unified IP MIB Reference 459
53-1002549-02
IPX cache table
IPX cache table
The IPX cache table contains information about the IPX forwarding cache for the router.
snIpxSapFiltOnAllPort
brcdIp.1.2.1.1.14
Syntax: Integer Read-write Applies the IPX RIP global filter list in the “snIpxSapGblFiltList” object to
all interfaces. This object adds all filter lists and deletes all SAP filter
lists from all ports. Before sending this command, the
“snIpxSapGblFiltList” object must be defined.
The following values can be written:
•
deleteAllInBound(2) – Deletes all in-bound filter lists from all
ports.
•
deleteAllOutBound(3) – Deletes all out-bound filter lists from all
ports.
•
addAllInBound(4) – Adds all in-bound filter lists to all ports.
•
addAllOutBound(5) – Adds all out-bound filter lists to all ports.
The following values can be returned on reads:
•
noSuch(0) – Set operation has not be performed.
•
valid(1) – Set operation is done and is valid.
snIpxTxDropPktsCnt
brcdIp.1.2.1.1.15
Syntax: Counter Read-only Shows the number of packets that were queued to be sent on a port by
the Layer 3 Switch, but then dropped.
snIpxTxFiltPktsCnt
brcdIp.1.2.1.1.16
Syntax: Counter Read-only The number of packets that were queued to be sent on a port that
matched an outbound IPX filter that was configured on the port.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snIpxCacheTable
brcdIp.1.2.1.2.1 None The IPX cache table.
snIpxCacheIndex
brcdIp.1.2.1.2.1.1.1
Syntax: Integer Read-only The table index for an IPX cache table entry.
snIpxCacheNetNum
brcdIp.1.2.1.2.1.1.2
Syntax: NetNumber Read-only Shows the network number containing the destination node.
snIpxCacheNode
brcdIp.1.2.1.2.1.1.3
Syntax: Physical address Read-only Shows the number of the destination node.
snIpxCacheOutFilter
brcdIp.1.2.1.2.1.1.4
Syntax: Integer Read-only Shows if an outbound cache filter has been enabled:
•
disabled(0)
•
enabled(1)