Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 336)

308 Unified IP MIB Reference
53-1002549-02
VLAN extended statistics
VLAN extended statistics
This section describes the MIB objects for the Virtual Local Area Network (VLAN) extended statistics
supported on G2 products of Brocade MLX series and Brocade NetIron XMR devices.
Use the extended-counters priority command to configure a module to enable per-VLAN or per-port,
or priority accounting (or extended counters) that applies to both ingress and egress counters. Use
the extended-counters routed-switched command to configure the system to count switched and
routed packets separately. The default value or the no form of the command configures the system
to count switched and routed packets combined. All the counters reset to “0” when the state is
changed. Also, the current counters that reset to “0” maintain an aggregate count. For more
information, refer Brocade MLXe and NetIron Family Configuration Guide.
NOTE
The Layer 2 VPN counters apply only to switched packets.
The following table lists the objects of extended statistics for VLAN.
snVLanByATCableRowStatus
brcdIp.1.1.3.2.5.1.4
Syntax: Integer Read-write Controls the management of the table rows. The following values
can be written:
•
delete(3) – Deletesthe row.
•
create(4) – Creates a new row.
•
modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row.
•
invalid(1) – Row is inoperative.
•
valid(2) – Row exists and is valid.
snVLanByATCableChassisSta
ticMask
brcdIp.1.1.3.2.5.1.5
Syntax: OCTET STRING Read-write This object is replaced by the “snVLanByATCableStaticPortList”
object.
Shows a list of ports that are statically configured to become port
members of a VLAN.
It has 32 octets.
snVLanByATCableVLanName
brcdIp.1.1.3.2.5.1.6
Syntax: DisplayString Read-write Shows the community string that can access this VLAN.
Valid values: Up to 32 characters
snVLanByATCableStaticPortL
ist
brcdIp.1.1.3.2.5.1.7
Syntax: OCTET STRING Read-write Shows a list of port indices that are configured to join membership
of the AppleTalk Cable VLAN. Each port index is a 16-bit integer in
big-endian order. The first 8 bits are the slot number; the other 8
bits are the port number.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
brcdVlanExtStatsTable
brcdIp.1.1.3.2.8 None Table contains the extended statistics for VLAN ports
of G2 and later modules. It is not applicable for G1
cards.
These statistics apply to Layer 2 VLANs as well as port
VLANs that are associated to IP interfaces (physical or
VE).