Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 472)

444 Unified IP MIB Reference
53-1002549-02
IP static route table
IP static route table
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
The IP static route table contains a list of static routes. These routes can be one of the following
types:
• Standard – The static route consists of the destination network address and network mask,
plus the IP address of the next-hop gateway.
• Interface-based – The static route consists of the destination network address and network
mask, plus the Layer 3 Switch interface through which you want the Layer 3 Switch to send
traffic for the route. Typically, this type of static route is directly attached to the destination
networks.
• Null – The static route consists of the destination network address and network mask, plus the
“null0” parameter. Typically, the null route is configured as a backup route for discarding traffic
if the primary route is unavailable.
The IP static route table also serves as the default route table.
snRtIpLoadShareMaxP
aths
brcdIp.1.2.2.1.18
Syntax: Integer32 Read-only Indicates the maximum number of routes that can be configured to
share the load.
snRtIpLoadShareMinPa
ths
brcdIp.1.2.2.1.19
Syntax: Integer32 Read-only Indicates the minimum number of routes that can be configured to
share the load.
snRtIpProtocolRouterId
brcdIp.1.2.2.1.20
Syntax: IpAddress Read-write Shows the router ID for all Internet Protocols.
snRtIpSourceRoute
brcdIp.1.2.2.1.21
Syntax: Integer Read-write Indicates if strict source routing is enabled to drop source routed
packets:
•
disabled(0)
•
enabled(1)
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snRtIpStaticRouteTable
brcdIp.1.2.2.2 None IP static route table.
snRtIpStaticRouteIndex
brcdIp.1.2.2.2.1.1
Syntax: Integer32 Read-only The table index for a static route entry.
snRtIpStaticRouteDest
brcdIp.1.2.2.2.1.2
Syntax: IpAddress Read-write Shows the destination IP address of the default route. The
address 0.0.0.0 is the IP address of the default router.