Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 703)

Unified IP MIB Reference 675
53-1002549-02
Chapter
67
Trap MIB Definition
In this chapter
• Objects to enable or disable standard traps . . . . . . . . . . . . . . . . . . . . . . . . 675
• Standard traps. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 676
• Proprietary traps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 681
• Examples . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 720
• General traps for the Brocade NetIron devices . . . . . . . . . . . . . . . . . . . . . . 721
This section describes the standard and proprietary traps that are supported in the Unified IP MIB.
Objects to enable or disable standard traps
NOTE
By default, all the traps are enabled.
The following objects from RFC 1213 are the standard objects that are supported in the Unified IP
MIB. They are used to set SNMP traps.
Name, OID, and syntax Access Description
snmpInTraps
1.3.6.1.2.1.11.19 Read-only Shows the total number of SNMP trap PDUs that have been
accepted and processed by SNMP.
snmpOutTraps
1.3.6.1.2.1.11.29 Read-only Shows the total number of SNMP trap PDUs that have been
generated by SNMP.
snmpEnableAuthenTrap
s
1.3.6.1.2.1.11.30 Read-write Indicates if the SNMP agent process is permitted to generate
authentication failure traps. The value of this object overrides any
configuration information. This objects provides a way to disable all
authentication failure traps.
NOTE: It is strongly recommended that this object to be stored in
the nonvolatile memory so that it remains constant
between re-initializations of the network management
system.