Brocade Communications Systems RFS6000 - Manual (Page 113)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 111
53-1001931-01
show
2
show wireless multicast-packet-limit
show wireless phrase-to-key [wep64|wep128] <pass-phrase>
show wireless qos-mapping {[wired-to-wireless|
wireless-to-wired]}
show wireless radio
{[<1-4096>|admission-control|all|beacon-table|config|monitor-table|statistics
|unadopted|
uptime|voice]}
show wireless radio
{[<1-4096>|all|beacon-table|monitor-table|unadopted|uptime]}
show wireless radio admission-control voice {<1-4096>}
show wireless radio config {[<1-4096>|default-11a|default-11an|
default-11b|default-11bg|default-11bgn]}
show wireless radio statistics {[<1-4096> {detail}|
long-interval|short-interval|voice {[<1-4096>|long-interval|
short-interval]}}
show wireless radio voice {<1-4096>}
show wireless radio-group {<1-256>}
show wireless regulatory <country code>
show wireless self-heal-config {[<1-4096>|all]}
show wireless sensor {[<1-48>|default-config]}
show wireless smart-rf [calibration-status|configuration|
history|radio]
show wireless smart-rf radio [config|local-status|map|
master-status|neighbors|spectrum] {<1-4096>|<MAC>|
all-11a|all-llbg]}
show wireless unapproved-aps
show wireless unauthorized-aps
show wireless wireless-controller-statistics {detail}
show wireless wlan [config {[<1-256>|all|enabled]}|statistics {<1-256>
{detail}}]
show wireless wips [configured-ap-def-essids|
configured-bad-essids|fake-ap-flood|filter-list| suspicious-ap]
Parameters
aap-version Displays the minimum adaptive firmware version string
ap [<1-48>|<MAC>|
config [<1-48>|<MAC>]] Status of the adopted access point
•
<1-48> – Defines the index of the access point
•
<MAC> – Sets the MAC address of a access point
•
config [<1-1024>|<MAC>] – Status of the configured access
point
•
<1-1024> – AP index from the “show wireless ap”
command
•
<MAC> – MAC address of the ap
ap-containment
[config|table] Rogue AP containment
•
config – Rogue AP Containment Parameters
•
table – Rogue AP Containment table
ap-detection-config Detected AP configuration parameters
ap-images Displays the access point images on the controller
ap-unadopted Lists unadopted access points
approved-aps Displays approved APs detected by access point scans