Brocade Communications Systems RFS6000 - Manual (Page 620)

618 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
1. Use
sensor
command to setup the sensor.
RFController(config-wireless)#sensor default-config ?
ip-mode configure the IP address mode of the sensors
wips-server-ip specify IP addresses of the WIPS server
Select either ip-mode or wips-server-ip as the sensor parameter.
2. Specify the VLAN over which the sensors are available. This will help the controller detect
them.
RFController(config-wireless)#sensor vlan 10
3. Use
convert-ap
command to convert the selected AP into a sensor directly from the controller.
RFController(config-wireless)#convert-ap 1 sensor
NOTE
To convert multiple APs’ to Sensor, do it one by one and do config modifications.