Brocade Communications Systems RFS6000 - Manual (Page 497)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 495
53-1001931-01
MAC Extended ACL config commands
16
mark
MAC Extended ACL config commands
Specifies the packet to mark
NOTE
Use a decimal value representation of ethertypes to implement permit/deny/mark designations for
a packet. An Extended MAC ACL provides the hexadecimal values for each listed ethertype. The
controller supports all ethertypes. Use the decimal equivalent of the ethertype listed in the CLI or
any other type of ethertype.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
mark [8021p|dscp|tos]
mark [8021p <vlan-priority-value>|dscp
<dscp-codepoint-value>|tos <tos-value>] [icmp|ip|tcp|udp]
mark [8021p <vlan-priority-value>|dscp
<dscp-codepointvalue>|tos <tos-value>] icmp [<source-IP/Mask>|any|host<IP>]
[<dest-IP/mask>|any|host <IP>]
{<ICMP-type> {<ICMPcode>}}
{log} {rule-precedence <1-5000>]}
mark [8021p <vlan-priority-value>|dscp
<dscp-codepointvalue>|tos <tos-value>] IP [<source-IP/mask>|any|host
<IP>][<dest-ip/mask>|any|host <IP>] {log} {rule-precedence <1-5000>}
mark [8021p <vlan-priority-value>|dscp
<dscp-codepointvalue>|tos <tos-value>] [tcp|udp]
[source-IP/Mask>|any|host<IP>] {eq <source-port>|range <starting-source-port>
<ending-source-port>} [<dest-IP/Mask|any|host <IP>] {eq <source-port>} {range
<starting-source-port> <ending-sourceport>} {log}
{rule-precedence <1-5000>}