Brocade Communications Systems RFS6000 - Manual (Page 650)

648 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
Parameters
<1-4096> Defines a single radio index.
<radio-list> Creates a list (1,3,7) or range (3-7) of radio indices.
add <1-4096> <MAC>
[11a|11an|11b|11bg|
11bgn] [br5181|br300|
br7131]} Adds the specified radio to the radio list at index specified for the
value in the range 1-4096.
•
[11a|11an|11b|11bg|11bgn] – The radio type
•
[br5181|br300|br7131] – Optional. The radio model. The
options available will depend on the radio type selected.
all-11a All 11a radios currently in configuration
all-11an All 11an radios currently in configuration
all-11b All 11b radios currently in configuration
all-11bg All 11bg radios currently in configuration
all-11bgn All 11bgn radios currently in configuration
antenna-mode
[diversity|mimo|primary|
secondary] Antenna diversity mode. Select diversity from:
•
diversity – Use full diversity (both antennas)
•
mimo – use MIMO
•
primary – Use primary antenna only
•
secondary – Use secondary antenna only
configure-8021X Configures the 802.1X username and password on adopted
access points
default-11a Adopts the default 11a configuration template
default-11an Adopts the default 11an configuration template
default-11b Adopts the default 11b configuration template
default-11bg Adopts the default 11bg configuration template
default-11bgn Adopts the default 11bgn configuration template
dns-name <WORD>
<AA-BB-CC-DD-EE-FF> Configures dns-name to be used in L3-Discovery on adopted
access-points.
•
<WORD> - Specify the dns-name the access-ports must use
(upto 127 characters)
•
<AA-BB-CC-DD-EE-FF> - Change the dns-name only on
the access-point with a specified MAC address. If not
specified, the dns-name update is sent to all currently
adopted access-points
lldp [hold-time|mode|
refresh-interval] Displays the commands related to LLDP advertisements.
•
hold-time <4-10>– Sets the HoldTime Multiplier value on
LCAP. The default value is 4.
•
<4-10> – Specifies the range of the HoldTime Multiplier
value in seconds.
•
mode – Sets the LLDP status on LCAP.
•
disable – Disables the LLDP advertisements.
•
refresh-interval <30-32768> – Sets the LLDP refresh
interval on LCAP. This parameter indicates the interval at
which LLDP frames are transmitted on behalf of the LLDP
agent.
•
<30-32768> – Specifies the range of Refresh Interval
Value in seconds.
NOTE: By default, the LLDP mode is disabled.