Brocade Communications Systems RFS6000 - Manual (Page 785)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 783
53-1001931-01
smart-rf config commands
25
Parameters
<1-4096> [antenna-gain |
coverage-rate |
lock-auto-assign |
radio-mac | rescuer] Sets the following parameters for the selected radio:
•
antenna-gain <GAIN> – Sets the antenna-gain value to GAIN
for the selected radio.
•
coverage-rate [1|2|5p5|6|9|11|12|18|24|36|48|54] –
Sets the coverage rate threshold value for under-coverage
detection to the selected value from the list.
•
lock-auto-assign [all|channel|detector|power|rescuer] –
Locks rf configuration from automatic smart rf assignments.
•
radio-mac <AA-BB-CC-DD-EE-FF> – Sets the radio MAC
address for the radio with the selected index.
•
rescuer {AA-BB-CC-DD-EE-FF <4-20> <0-65535> } – Sets the
MAC address for the rescuer radio. The following parameters
are also set:
•
<4-20> – Boost power to cover for the defective radio.
•
<0-65535> – Attenuation from the rescuer radio
to the selected radio. This is for information
purposes only.
•
width [auto|dual|single] - Configures channel-width
preference during calibration
•
auto - Auto channel-width - lets smart-rf figure out the
best channel-width
•
dual - Dual channel-width - 40 MHz
•
single - Single channel-width - 20 MHz
AA-BB-CC-DD-EE-FF
[antenna-gain |
coverage-rate |
lock-auto-assign | rescuer] Sets the following parameters for the selected radio.
•
antenna-gain <GAIN> – Sets the antenna-gain value to GAIN
for the selected radio.
•
coverage-rate [1|2|5p5|6|9|11|12|18|24|36|48|54] –
Sets the coverage rate threshold value for under-coverage
detection to the selected value from the list.
•
lock-auto-assign [all|channel|detector|power|rescuer] –
Locks rf configuration from automatic smart rf assignments.
•
rescuer {AA-BB-CC-DD-EE-FF <4-20> <0-65535> }– Sets the
MAC address for the rescuer radio. The following parameters
are also set:
•
<4-20> – Boost power to cover for the defective radio.
•
<0-65535> – Attenuation from the rescuer radio
to the selected radio. This is for information
purposes only.
RADIO [antenna-gain|
coverage-rate|
lock-auto-assign] Sets the radio parameters to a set of radio indices.
•
antenna-gain <GAIN> – Sets the antenna-gain value to GAIN
for the selected radio.
•
coverage-rate [1|2|5p5|6|9|11|12|18|24|36|48|54] –
Sets the coverage rate threshold value for under-coverage
detection to the selected value from the list.
•
lock-auto-assign [all|channel|detector|power|rescuer] –
Locks rf configuration from automatic smart rf assignments.
all-11a [antenna-gain|
coverage-rate|lock-auto-ass
ign] Sets the radio parameters for all 802.11a radios.
•
antenna-gain <GAIN> – Sets the antenna-gain value to GAIN
for the selected radio.
•
coverage-rate [1|2|5p5|6|9|11|12|18|24|36|48|54] –
Sets the coverage rate threshold value for under-coverage
detection to the selected value from the list.
•
lock-auto-assign [all|channel|detector|power|rescuer] –
Locks rf configuration from automatic smart rf assignments.