Brocade Communications Systems RFS6000 - Manual (Page 552)

550 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
DHCP Server Class config commands
18
option
DHCP Server Class config commands
Specifies a value for DHCP user class options
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
option user-class <class-name>
Parameters
Example
RFController(config-dhcpclass)#option user-class MC800
RFController(config-dhcpclass)#
Creating a DHCP user class
Complete the steps below to create a DHCP user class:
5. Create a DHCP class named RFControllerDHCPclass. The controller supports a maximum of 32
DHCP classes.
RFController(config)#ip dhcp class RFControllerDHCPclass
RFController(config-dhcpclass)#
6. Create a USER class named
MC800
. The privilege mode changes to
(config-dhcpclass)
. The
controller supports a maximum of 8 user classes per DHCP class.
RFController(config-dhcpclass)#option user-class MC800
RFController(config-dhcpclass)#
7. Create a Pool named
WID
, using the
(config)#
mode.
RFController(config)#ip dhcp pool WID
RFController(config-dhcp)#
8. Associate the DHCP class, created in Step 1 with the pool created in Step 3. The controller
supports the association of 8 DHCP classes with a pool.
RFController(config-dhcp)#class RFControllerDHCPclass
RFController(config-dhcp-class)#
9. The controller moves to a new mode (config-dhcp-class). Use this mode to add an address
range for the DHCP class associated with the pool.
RFController(config-dhcp-class)#address range 11.22.33.44
user-class <class-name> Creates/modifies DHCP server user class options
•
<class-name> – ASCII value of user-class option