Brocade Communications Systems RFS6000 - Manual (Page 696)

694 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
•
authentication-protocol [chap|pap] – Sets the RADIUS
Authentication Protocol for RADIUS request. Select from
CHAP or PAP.
•
dscp <0-63> – Specify a Differentiated Services Code Point
(DSCP) value to provide QoS to RADIUS packets. Set a value
in the range 0 to 63.
•
dynamic-authorization enable – Configures support for
RADIUS dynamic authorization extensions such as
Disconnect Message, and Change-Of-Authorization, as
described in RFC 3576.
•
enable – Enables this feature.
•
dynamic-vlan-assignment enable – Allow users to be
assigned to RADIUS server specified VLANs, instead of only
the vlan that is mapped to this wlan.
•
enable – Enables this feature.
•
mac-auth-format
[no-delim|pair-colon|pair-dash|quad-dot|middle-dash] –
Set the MAC address format to use.
•
middle-dash – Dash Delimiter in the middle -
AABBCC-DDEEFF
•
no-delim – No Delimiter - AABBCCDDEEFF
•
pair-colon – Colon Delimiter per Pair -
AA:BB:CC:DD:EE:FF
•
pair-dash – Dash Delimiter per Pair -
AA-BB-CC-DD-EE-FF
•
quad-dot – Dot Delimiter per Four Hex -
AABB.CCDD.EEFF
•
wireless-client timeout <1-300> retransmit <1-100> –
Modifies RADIUS/802.1X supplicant related parameters.
•
timeout <1-300> – Sets the Time the wireless
controller waits for a response from the wireless-client
before retrying. Set a value in the range 1 to 300.
•
retransmit <1-100> – Sets the number of retries before
the wireless controller will give up and disassociate the
wireless-client. Set a value in the range 1 to 100.