Brocade Communications Systems RFS6000 - Manual (Page 760)

758 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
SOLE config commands
24
locate
SOLE config commands
Configures location commands
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
locate [aeroscout|wireless-client|ekahau]
locate wireless-client [<MAC-Addr>|enable|interval]
locate ekahau [enable|interval]
Parameters
Usage Guidelines
Use
[no] locate [aeroscout|wireless-client|ekahau]
to rollback and disable all the
configurations performed using
locate
command
Example
RFController(config-rtls-sole)#locate aeroscout enable
RFController(config-rtls-sole)#
RFController(config-rtls-sole)#locate aeroscout interval 300
RFController(config-rtls-sole)#
aeroscout
[enable|interval <5-3600> Locates aeroscout tags
•
enable – Enables on-board aeroscout location engine service
•
interval <5-3600> – Configures location interval for
on-board locationing of aeroscout tags in seconds
wireless-client
[<MAC-Addr>|
enable|interva
<5-3600> l]
Locates specified wireless client
•
<MAC-Addr> enable – Enables location of specified Client
•
enable – Enables location of all specified clients
•
interval <5-3600> – Configures clients location interval for
locationing of clients in seconds
NOTE: The controller currently supports locationing of 512 clients
only.
ekahau [enable|
interval<5-3600> Locates ekahau tags
•
enable – Enables on-board locationing ofekahau tags
•
interval <5-3600> – Configures location interval for on-board
locationing of ekahau tags in seconds