Brocade Communications Systems RFS6000 - Manual (Page 520)

518 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
DHCP Config commands
17
dns-server
DHCP Config commands
Sets the DNS server’s IP address available to all DHCP clients connected to the pool. Use the
no
dns-server
command to remove the DNS server list.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
dns-server <IP address>
Parameters
Usage Guidelines
For DHCP clients, the DNS server’s IP address maps the host name to an IP address. DHCP clients
use the DNS server’s IP address based on the order (sequence) configured.
Example
RFController(config-dhcp)#dns-server 2.2.2.222
RFController(config-dhcp)#
dns-server <IP address> Configures the DNS server’s IP address
•
<IP address> – Sets the server's IP address. Up to
8 IPs can be set.