Brocade Communications Systems RFS6000 - Manual (Page 54)

52 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Common commands
2
wireless [ap-history|
clear-ap-log
|custom-cli|dot11i|
dump-core|
enhanced-beacon-table|
enhanced-probe-table|
free-packet-watermark
|idle-radio-send-multicast|
legacy-load-balance
|map-radios|
radio-misc-cfg
|rate-scale|
request-ap-log
|save-ap-log
|snmp-trap-throttle|
sync-radio-entries|
vlan-cache] Wireless parameters
•
ap-history [clear|enable] – Access-point history
•
clear – Delete all history of all APs
•
enable – Enable the tracking of AP history
•
clear-ap-log <1-1024> – Clears the AP logs
•
custom-cli [sh-wi-wireless-client|sh-wi-radio] – Customize the
output of some summary cli commands in wireless
•
sh-wi-wireless-client [ap-locn|ap-name|channel|
dot11-type|ip|last-heard|mac|radio-bss|
radio-desc|radio-id|ssid|state|username|vlan
|wlan-desc|wlan-id|username] – Customize the output
of the "show wireless wireless-client’ command
•
ap-locn – The location of the AP where the
wireless-client is associated
•
ap-name – The name of the AP where the
wireless-client is associated
•
channel – The channel of the radio where the
wireless-client is associated
•
dot11-type –The dot11 radio type of the
wireless-client
•
ip – The IP address of the wireless-client
•
last-heard – the time when a packet was last
received from the wireless-client
•
mac – MAC address of wireless-client
•
radio-bss – the bssid of the radio where the
wireless-client is associated