Brocade Communications Systems RFS6000 - Manual (Page 310)

308 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Global Configuration commands
5
username
Global Configuration commands
Establishes user name authentication
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
username <name> [access|password|privilege]
username <name> access [console|ssh|telnet|web]
username <name> password [0 <password>|1 <password>|
<password>]
username <name> privilege [helpdesk|monitor|nwadmin|
superuser|sysadmin|webadmin]
Parameters
Example
RFController(config)#username GoldenController
RFController(config)#
RFController(config)#username Aeyjey access console ssh telnet web
RFController(config)#username JohnDoe privilege sysadmin webadmin nwadmin
<name> Enter a name to authenticate the controller, the username should
be between 1 and 28 characters.
•
access [console|ssh|telnet|web]– Sets the user access
mode
•
console – Only allowed from console
•
ssh – Only allowed from ssh
•
telnet – Only allowed from telnet
•
web – Only allowed from applet (webUI)
•
password [0 <password>|1 <password>|<password>] –
Specifies the password for the user
•
0 – Password is specified UNENCRYPTED
•
1 – Password is encrypted with SHA1 algorithm
•
<password> – User password
•
plaintext password length should be between 8
and 32 letters
•
encrypted password length should be 40 letters)
•
privilege [helpdesk|monitor|nwadmin|superuser|
sysadmin|webadmin] – Sets user access privilege
•
helpdesk – Helpdesk (troubleshooting) access
•
monitor – Monitor (read-only) access
•
nwadmin – Network (wired & wireless) admin access
•
superuser – Superuser (root) access
•
sysadmin – System (general system configuration)
admin access
•
webadmin – Web auth (hotspot) user admin access