Brocade Communications Systems RFS6000 - Manual (Page 519)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 517
53-1001931-01
DHCP Config commands
17
default-router
DHCP Config commands
Configures the default router or gateway IP address for the network pool. To remove the default
router list, use the
no default-router
command.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
default-router <IP>
Parameters
Usage Guidelines
The IP address of the router should be on the same subnet as the client subnet.
Example
RFController(config-dhcp)#default-router 2.2.2.1
RFController(config-dhcp)#
default-router
< IP> Specifies the default router IP address for the network
pool
•
< IP> – Sets the router's IP address