Brocade Communications Systems RFS6000 - Manual (Page 512)

510 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
DHCP Config commands
17
bootfile
DHCP Config commands
Assigns a bootfile name for the DHCP configuration on the network pool
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
bootfile <FILE>
Parameters
Usage Guidelines
Use the
bootfile
command to specify the boot image. The boot file contains the boot image name
used for booting the bootp clients (DHCP clients). Only one boot file is allowed per pool.
Use {
no} bootfile
command to remove the bootfile. Do not use the <file name> with the bootfile
command as only one bootfile exists per pool. The command
[no] bootfile
removes the existing
command from the pool.
Example
RFController(config-dhcp)#bootfile bootexample.txt
RFController(config-dhcp)#
bootfile <FILE> Sets the boot image for BOOTP clients. The file name
can contain letters, numbers, dots and hyphens.
Consecutive dots and hyphens are not permitted.