Brocade Communications Systems RFS6000 - Manual (Page 633)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 631
53-1001931-01
Wireless configuration commands
20
load-balance
Wireless configuration commands
Configures the user load balance mode
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
load-balance [by-count|by-throughput]
Parameters
Example
RFController(config-wireless)#load-balance by-throughput
RFController(config-wireless)#
by-count In load balance by user count, the load on the radio is measured
by the number of clients associated. The desired balance is to
have equal number of clients on the radios in the group. By
default, the load balance is configured for
by-count when the controller boots up with factory default
configuration.
by-throughput In load balance by radio throughput (threshold 1 Mbps) the load
on the radio is measured by the current average throughput rate.
The desired balance is to have similar wireless traffic on the
radios in the group.