Brocade Communications Systems RFS6000 User Manual

Page 415

Advertising
background image

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide

413

53-1001931-01

Interface config commands

12

Parameters

Usage Guidelines

IPv4 commands are not allowed on a L2 interface. Use the

ip access-group

command to attach

an access list to an interface. Use the

no ip access-group

command to remove the access list

from the interface

Use

mac access-group

to attach a MAC access list to an interface

Use the

{no} ip [options]

command to undo IP based interface configurations

Example

RFController(config-if)#ip access-group 110 in

RFController(config-if)#

RFController(config-if)#ip address 192.168.234.1/24

RFController(config-if)#

access-group

[<1-99>|

<100-199>|

<1300-1999>|

<2000-2699>]

Defines the access group

<1-99> – Sets the IP standard access list

<100-199> – Sets the IP extended access list

<1300-1999> – Sets the IP standard access list
(expanded range)

<2000-2699> – Sets the IP extended access list
(expanded range)

WORD in – Defines the access list name

in – Sets incoming packets

ip address [ <IP Mask>
{secondary}|dhcp]

Sets a static IP address and network mask for a Layer 3 SVI
(Controller Virtual Interface)

<IP/ Mask> {secondary} – Sets the IP address (10.0.0.1/8)

secondary – Defines an optional secondary IP address

dhcp – Uses a DHCP Client to obtain an IP address for the
interface (this enables DHCP on a Layer 3 SVI)

helper-address <IP>

Forwards DHCP and BOOTP packets

<IP> - Defines the IP to which DHCP and BOOTP packets
are forwarded

NOTE: IP helper addresses can only be applied on SVI but not

on the physical interfaces.

nat [inside|outside]

Sets Network Address Translation (NAT) parameters

inside Inside interface

outside Outside interface

arp [rate-limit

<1-1000000>

|

trust]

Sets arp for the packets

rate-limit <1-1000000> Displays the allowed rate in
packets per second

trust Displays trust state for arp responses coming in this
interface

dhcp trust

Sets dhcp trust state for dhcp responses coming in this
interface

Advertising
This manual is related to the following products: