Brocade Communications Systems RFS6000 - Manual (Page 689)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 687
53-1001931-01
Wireless configuration commands
20
hotspot [allow-eap|
allow-list|authentication|dn
-whitelist|cache-ageout|
connection-mode|
ntf-logout-port|portal-api|pr
e-auth-vlan|
redirect-to-hostname|
simultaneous-users|
query|webpage|
webpage-location] Modifies hotspot related parameters
•
allow-eap – allow EAP authentication in addition to web
based login.
•
allow-list <1-32> <IP> – Specifies the allowed list that user
can access without prior authentication. Typically this would
be the external web-page's IP address.
•
<1-32> – Allow-list Rule index value.
•
<IP> – Allow-list IP address. This parameter refers to a
specific IP address to which unauthenticated
wireless-clients can connect to. It does not specify a
network or a subnet.
•
authentication [free|radius] – Sets authentication type for
singed users
•
free – Provides the user a guest login option.
•
radius – Provides radius authentication option to login
•
dns-whitelist <WORD> – Configures host whitelist.
•
LINE – Whitelist name.
•
cache-ageout <5-86400> – The time duration in seconds to
ageout the cache after Client disassociation.
•
connection-mode [https|https] – Configures the connection
mode as http or https
•
http – Specifies connection-mode as http
•
https – Specifies connection-mode as https
•
ntf-logout-port <0-65535> – Configures the port to send the
NTF-Logout when the device is in external hotspot mode.
•
Portal-api [enable|shared-secret <LINE>] – Configures the
HTTPS-POST API interface used by external web portals
•
enable – Enables support for the HTTPS-POST API.
•
shared-secret <LINE> – Configures the security
shared-secret between the web portal and the switch
•
pre-auth-vlan <1-4096> – Configures default vlan to be used
until users get authorized. Specify the index of the vlan
•
max-login-attempts <0-10> – Modifies hotspot maximum
login attempts.
•
<0-10> – Login attempts between 0-10.
•
query [<1-10>|<query-list>] – Specifies queries to be
appended to redirection URL.
•
<1-10> – A single index.
•
<query-list> – A list of indices.
•
redirect-to-hostname – Use the Hostname/System-Name in
the redirection URL instead of the IP address of the
controller.
•
simultaneous-users <0-8192> – Specifies how many
simultaneous MAC address can be allowed for a given end
user.
•
<0-8192> – The number of MAC addresses that are
allowed to use that username at the same time. 0
implies disabling of the checks.