Static-channel-group, Static-channel-g roup – Brocade Communications Systems RFS6000 User Manual
Page 431
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
429
53-1001931-01
Interface config commands
12
static-channel-group
Adds an interface to a static channel group
Displays current system information running on the controller.
Supported in the following platforms:
•
Mobility RFS7000 Controller
•
Mobility RFS4000 Controller
NOTE
The Mobility RFS6000 Controller does not support this command.
Syntax
static-channel-group <1-4>
Parameters
Usage Guidelines
This command aggregates individual giga ports into a single aggregate link to provide greater
bandwidth. The static channel group is used to provide additional bandwidth in multiples of 1Gbps
on the controller. All MAC layer and higher protocols see only the static channel group (aggregate
link) rather than the individual ports that comprise it.
Example
RFController(config-if)#static-channel-group 2
RFController(config-if)#
<1-4>
Sets a static channel group to associate the link with