Brocade Communications Systems RFS6000 - Manual (Page 673)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 671
53-1001931-01
Wireless configuration commands
20
show
Wireless configuration commands
Displays current system information running on the controller
For other show commands, see Chapter 2, Section show on page 2-59 .
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
NOTE
The following commands display only for the Mobility RFS6000 Controller and the Mobility RFS4000
Controller
- power
The following commands display only for the Mobility RFS7000 Controller and the Mobility RFS4000
Controller:
- port-channel
- static-channel-group
Syntax
show <paramater>
Parameters
Example
RFController (config-wireless)#show ?
aap-wlan-acl wlan based acl
aap-wlan-acl-stats IP filtering wlan based statistics
access-list Internet Protocol (IP)
aclstats Show ACL Statistics information
alarm-log Display all alarms currently in the system
autoinstall autoinstall configuration
banner Display Message of the Day Login banner
boot Display boot configuration.
clock Display system clock
commands Show command lists
crypto encryption module
debugging Debugging information outputs
dhcp DHCP Server Configuration
environment show environmental information
file Display filesystem information
firewall Wireless firewall
ftp Display FTP Server configuration
history Display the session command history
interfaces Interface status
ip Internet Protocol (IP)
ldap LDAP server
licenses Show any installed licenses
logging Show logging configuration and buffer
? Displays all the parameters for which information can be viewed
using the show command