B. simulation parameters, Functionality configuration parameters, Simulation parameters – Altera Triple Speed Ethernet MegaCore Function User Manual
Page 196
B
Simulation Parameters
2014.06.30
UG-01008
Functionality Configuration Parameters
You can use these parameters to enable or disable specific functionality in the MAC and PCS.
Table B-1: MegaCore Functionality Configuration Parameters
Default
Description
Parameter
Supported in configurations that contain the 10/100/1000 Ethernet MAC
1000
10: Enables MII.
100: Enables MII.
1000: Enables GMII.
ETH_MODE
0
Sets the
HD_ENA
bit in the
command_config
register. See
Command_Config Register (Dword Offset 0x02)
on
page 6-7.
HD_ENA
15
Sets the
pause_quant
register. See
Registers (Dword Offset 0x00 – 0x17)
on page 6-3.
TB_MACPAUSEQ
0
Sets the
PAUSE_IGNORE
bit in the
command_config
register. See
Command_Config Register (Dword Offset
on page 6-7.
TB_MACIGNORE_PAUSE
0
Sets the
PAUSE_FWD
bit in the
command_config
register.
See
Command_Config Register (Dword Offset 0x02)
on page 6-7.
TB_MACFWD_PAUSE
0
Sets the
CRC_FWD
bit in the
command_config
register. See
Command_Config Register (Dword Offset 0x02)
on
page 6-7.
TB_MACFWD_CRC
0
Sets the
ADDR_INS
bit in the
command_config
register.
See
Command_Config Register (Dword Offset 0x02)
on page 6-7.
TB_MACINSERT_ADDR
1
Sets the
PROMIS_EN
bit in the
command_config
register.
See
Command_Config Register (Dword Offset 0x02)
on page 6-7.
TB_PROMIS_ENA
©
2014 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words
and logos are trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other
words and logos identified as trademarks or service marks are the property of their respective holders as described at
www.altera.com/common/legal.html
. Altera warrants performance of its semiconductor products to current specifications in accordance with
Altera's standard warranty, but reserves the right to make changes to any products and services at any time without notice. Altera assumes
no responsibility or liability arising out of the application or use of any information, product, or service described herein except as expressly
agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device specifications before relying on any published
information and before placing orders for products or services.
www.altera.com
101 Innovation Drive, San Jose, CA 95134