IDEC MicroSmart - Manual (Page 75)

2: M ODULE S PECIFICATIONS
« FC4A M ICRO S MART U SER ’ S M ANUAL » 2-55
FC4A-K1A1 (Analog Output Module) — Screw Terminal Type
Applicable Terminal Block: FC4A-PMT11P (supplied with the analog output module)
FC4A-K2C1 (Analog Output Module) — Screw Terminal Type
Applicable Terminal Block: FC4A-PMT10P (supplied with the analog output module)
Terminal No. Channel
+
24V DC –
+
OUT
–
NC
— NC
NC
NC
— NC
NC
•
Connect a fuse appropriate for the applied voltage and current draw, at the position shown in the
diagram. This is required when equipment containing the MicroSmar t is destined for Europe.
•
Do not connect any wiring to unused terminals.
Fuse
+ –
24V DC
+
–
Analog voltage/current
input device
Terminal No. Channel
24V
24V DC 0V
NC —
V+
OUT0 I+
–
V+
OUT1 I+
–
Fuse
+ –
24V DC
+
–
Analog voltage
input device
+
–
NC
NC
Analog current
input device
•
Connect a fuse appropriate for the applied voltage and current draw, at the position shown in the
diagram. This is required when equipment containing the MicroSmar t is destined for Europe.
•
Do not connect any wiring to unused terminals.
•
– terminals of output channels OUT0 and OUT1 are interconnected.