INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 170)

p
STC-2000A DEPOSITION CONTROLLER
y
Editing an I/O Program
In order to get to the I/O screens, you need to navigate through the following sequence. From the
RunTime Screen, press the fixed MENU key. When the MAIN MENU appears, press the EXECUTIVE
MENU key and then press the I/O SETUP key and the unit will display the following screen. Rungs (I/O
SETUP Program lines) can range from 001 (END statement only) to 999 (memory constraints aside). 001
and 1 refer to the same rung, etc.
Figure- 16.10: I/O SETUP MAIN Menu (or 1 st I/O SETUP Menu) .
SECTION 5.11
Top Level I/O Menu:
See Fig. 5.3. Typical
I/O Program: (with line #
002 in the edit position)
See Fig. 5.4.
central area
always
contains the
line (rung)
that can be
edited. This
is the EDIT
line. The
down arrows
point to
I/O Program
Checksum
i i
scrolling
line
numbers
The 2 nd of 3 lines
displayed is the line
to be edited
(indicated by -
↓↓-
immediately over the
line to be edited)
Figure- 17.11: EDT (edit) menu with typical I/O Program values.
Figure 5.3 is the top level of the I/O menu. Figure 5.5 shows the structure of the various menus.
By pressing the fixed STATUS key while in this set of menus, you will be taken back to the RunTime
screen. The BAK key navigates back up one level and cancels unfinished EDTs (edits). The BYE key
returns to the Executive MENU.
SECTION 5.XX page 170 of 292