INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 92)

p
STC-2000A DEPOSITION CONTROLLER
y
previously unseen, numbers are now occupying the last three of the four displayed lines. The cursor is
always moved to a higher numbered step number (list line) with each press of the DOWN
↓ key (except at
the last step). When the edit cursor is coincidental with the last step and DOWN
↓ is pressed, no action is
taken other than activation of the beep annunciator.
Starting with the cursor at step 01, pressing down
↓ three times moves the edit cursor alone. Scrolling has
the same behavior in all places/menu levels.
Pressing the down
↓ key once again causes the four-line window into the list to be shifted ahead by three
lines as shown below. The edit cursor moves to the newly appearing, next consecutive list line. At this
point, the UP
↑ key could be pressed one time and the down ↓ key could be pressed three times with only
the edit cursor moving, that is, before the list lines in the four-line window would change.
The following sequence shows the scrolling behavior using the UP
↑ key. Again, scrolling has the same
behavior in all places/menu levels.
Press the UP
↑ key three times for the following result.
SECTION 3.XX page 92 of 292