INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 6)

p
STC-2000A DEPOSITION CONTROLLER
y
Quick Index
If you are already familiar with and know how to use this product, proceed in this section.
What do you need to do? [also, consult table of contents and index]
[see cautions on previous page]
1. Basic System Functionality
a) Select between Process Sequencing and process Non-sequencing.
b) Invoke the Test Mode.
c) Invoke the manual mode.
d) Set up host port communications.
1) user programmable settings.
2) physical connections
3) communication protocols and commands
e) Set LCD bias/contrast.
f) Set unit time/date.
g) View installed options information.
h) Configure FILM, PROCESS, and MAP parameters.
i) Set BEEPER on/off.
2. Working Process Functionality
a) Runtime Screen, STATUS key & screens: Alternate Runtime, indexer & channel screens.
b) Select Crystal sensor.
1) Sensor connections.
c) Power supply control.
1) Power supply connections.
d) Adjust power level manually (in manual mode).
e) Input card control.
f) Output card control.
g) Select and Run an I/O program.
h) Write an I/O program.
i) Shutter control.
Turn to
Section
10.xx
j) Select crystal stability indicators L/Q, etc.
k) Select / use Sample and Hold.
3. Memory
a) Purge the user programmed memory.
b) Set user programmed memory to factory settings.
c) Download user programmable and system parameters to a memory module.
d) Upload user programmable and system parameters from a memory module.
e) Checksums of user programmed parameters.
4. Additional Process Parameters
a) View or program I/O programming.
b) View process accounting history.
5. Essential Hardware and Programmed Parameters, Error Conditions
a) Missing or failed Source Sensor Card.
b) Minimum parameter values in non-sequencing mode.
c) Minimum parameter values in sequencing mode.
d) Input/Output card setup.
e) Memory module/memory module interface card setup.
[Useage example: What do you want to do? Set LCD contrast. Find this on above list at 1.e). Turn to Section 10.XX and
find 1.e) description, etc.]
(If you don't know how to use this product but still think you know what you are doing, don't use the above)
SECTION 1.XX page 6 of 292