Stc-2000a deposition controller – INFICON STC-2000A Thin Film Deposition Controller Operating Manual User Manual
Page 178
p
STC-2000A DEPOSITION CONTROLLER
y
The 5 key type menus are shown immediately below.
EDT/CHG
or simply
CHG (change)
MENUs
1
st
of 5
Edit/Change
menu types
2
nd
of 5
Edit/Change
menu types
3
rd
of 5
Edit/Change
menu types
4
th
of 5
Edit/Change
menu types
5
th
of 5
Edit/Change
menu types
Token keys (logical operators, command function/ID# combinations)
IN:
Used to input a variable. This can be used on any of the states. The current state of the
variable will be pushed on the stack when the term is processed or scanned. When inputing
from scalar (as in softnode use) the stack result is scalar. When inputing from Boolean or
event, the result on the stack is Boolean.
OUT:
Used to output to an output or user definable soft node. If an Out is specified to a read only
state (an Input for example), an error message will appear on the display. The term being
scanned causes the top of the stack to be popped and sent to the output. When going to scalar
(as in softnode use) the stack value result is scalar. When going from scalar to Boolean the
result on the stack is interpreted as Boolean (i.e. 0 = False, non-zero = True).
SECTION 5.XX
page 178 of 292