INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 218)

p
STC-2000A DEPOSITION CONTROLLER
y
______________________________________________________________________
Parameter 18
NA access value: OBSO Was ieee-488 address.
______________________________________________________________________
Parameter 19
NA access value: OBSO Was bit bus address.
______________________________________________________________________
Parameter 20
NA access value: OBSO Was gpib checksum control param code.
______________________________________________________________________
Parameter 21
NA access value: OBSO Was line frequency param code.
______________________________________________________________________
Parameter 22
Sequence Inhibit Inhibit Sequence Mode
access value: SQINH sequence inhibit, set true when cant sequence, Needs reset.
Value Range 0,1
Units None
This parameter (when set to 1) allows a STC-2000A to operate like a non SQ. This can be polled/set via
RS232 or changed on the SERVICE menu (see Section 2).
______________________________________________________________________
Parameter 23
Recorder Out Channel
access value: ROUTS Analog output channel select, when ARFNC not off, then active datalogging
value output to analog channel 1 or 2 providing no conflict with process control.
Units None
1 – 2 selects an analog output channel for use (if not off and not used as a source)
______________________________________________________________________
Parameter 24
N.A.
______________________________________________________________________
Parameter 25
N.A.
______________________________________________________________________
Parameter 26
N.A.
______________________________________________________________________
Parameter 27
N.A.
______________________________________________________________________
Parameter 28
I/O Slot 1 Type
access value: REQIO1 Require Input/Output 1 in system, CFGIOS_class DSBL/Inp/Outp
Value Range UNUSED (DISABLED) / INPUT / OUTPUT
Units None
______________________________________________________________________
Parameter 29
I/O Slot 2 Type
access value: REQIO2 Require Input/Output 2 in system, CFGIOS_class
Value Range UNUSED (DISABLED) / INPUT / OUTPUT
Units None
______________________________________________________________________
Parameter 30
I/O Slot 3 Type
access value: REQIO3 Require Input/Output 3 in system, CFGIOS_class
Value Range UNUSED (DISABLED) / INPUT / OUTPUT
SECTION 6.XX page 218 of 292