INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 234)

p
STC-2000A DEPOSITION CONTROLLER
y
N.A.
______________________________________________________________________
Parameter 34
N.A.
______________________________________________________________________
Parameter 35
N.A.
______________________________________________________________________
Parameter 36
N.A.
______________________________________________________________________
Parameter 37
N.A.
______________________________________________________________________
Parameter 38
N.A.
______________________________________________________________________
Parameter 39
access: AMAPID active map, contains 1..10 indicating current active map.
______________________________________________________________________
Parameter 40
access: IO_SCALAR_ANALOG, numeric value 0..255 which controls a chart recorder analog output value
0..FullScale if chart recorder option set to IOACC control mode.
______________________________________________________________________
Parameter 41
access: LFOVER, xtal life over limit bit map, bits set for xtal channels which are giving valid readings for
which the life value is less than the limit value in the active film program.
______________________________________________________________________
Parameter 42
access: ZPWRS, bit map of which sources are at 0 power or unused, 1 if source has power or is strip-chart
recorder usage.
______________________________________________________________________
Parameter 43
access: XTLAVAIL, bit map in pairs, shows what modules are avail.
______________________________________________________________________
Parameter 44
access: IO1_MODSTS I/O slot 1 module status.
______________________________________________________________________
Parameter 45
access: IO2_MODSTS I/O slot 2 module status.
______________________________________________________________________
Parameter 46
access: IO3_MODSTS I/O slot 3 module status.
______________________________________________________________________
Parameter 47
access: IO4_MODSTS I/O slot 4 module status.
______________________________________________________________________
Parameter 48
access: XTLDEADMAP Bitmap, sensors detected as dead.
______________________________________________________________________
Parameter 49
access: XTLSBYMAP Bitmap, sensors in standby.
______________________________________________________________________
Parameter 50
access: XTLUSMAP Bitmap, sensors in use contributing.
______________________________________________________________________
Parameter 51
SECTION 6.XX page 234 of 292