INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 97)

p
STC-2000A DEPOSITION CONTROLLER
y
By using the arrow up/down keys, the order of entry could be to change the modes of lines 5, 6 and 7, then
change the FILM#s of lines 5, 6, and 7 and then change the thickness of lines 5, 6, and 7.
Once in the edit/change mode, different parameters can be changed without leaving the edit mode.
Special Cases
The following screen appears when all of the total unit memory has been used. As the message relates,
recipe memory is used in its entirety. Although there can be up to 99 layers (steps) per process recipe and
up to 9 recipes, there is not enough unit memory to have 99 layers for each of all nine recipes. Press the OK
key to clear the message screen.
The following screen appears when an active process is running and someone is attempting to edit the
process while it is running. Press the OK key to clear the message screen.
If the PASSWORD LOCK# under the SYSTEM CONFIG. key on the EXECUTIVE menu has a value
other than zero (a non-zero value enables password and is itself the password) the following screen will
appear when the EDT (edit) key is pressed. The EXECUTIVE menu key is on the MAIN menu.
Enter the lockcode number value in the same way as previously described for other number entries.
SECTION 3.XX page 97 of 292