Wt (wait), Ri1 restores the tripp, Trippoint – Yaskawa SMC–4000 User Manual
Page 258
248
SMC–4000 User Manual
WT (Wait)
[Trippoint]
DESCRIPTION:
The WT command is a trippoint used to time events. After this command is executed, the controller will
wait for the number of samples specified before executing the next command. If the
command has not been used to change the sample rate from 1 msec, then the units of the Wait command are
milliseconds.
ARGUMENTS: WT n
where
n is an unsigned integer
USAGE:
EXAMPLES:
Assume that 10 seconds after a move is over a relay must be closed.
While Moving
Yes
Minimum Value
0
In a Program
Yes
Maximum Value
2147483647
Command Line
Yes
Default Value
---
Can be Interrogated
No
Default Format
---
Used as an Operand
No
#A
Program A
PR 50000
Position relative move
BG
Begin the move
AM
After the move is over
WT 10000
Wait 10 seconds
SB 1
Turn on relay
EN
End Program