Bv (burn variables) – Yaskawa SMC–4000 User Manual
Page 82
Advertising
72
SMC–4000 User Manual
BV (Burn Variables)
[General]
DESCRIPTION:
The BV command saves the defined variables and arrays in non-volatile EEPROM memory. This command
typically takes up to 2 seconds to execute and must not be interrupted. If the burn is disrupted by power
failure, a memory checksum error will result. The controller returns a <:> when the Burn variables are
complete.
ARGUMENTS: None
USAGE:
Note: A checksum error can only be cleared by performing a master reset, which is the ASCII
characters CTRL R and CTRL S snt over the serial port.
While Moving
No
Default Value
---
In a Program
No
Command Line
Yes
Can be Interrogated
No
Used as an Operand
Yes
Advertising