Yaskawa SMC–4000 User Manual
Page 292
282
SMC–4000 User Manual
You may also perform profiled position corrections in the electronic gearing mode. Suppose, for example,
that you need to advance the slave 10 counts. Simply command:
IP ,10
Specify an incremental position movement of 10 on B axis.
Under these conditions, this IP command is equivalent to:
PR,10
Specify position relative movement of 10 on B axis
BGB
Begin motion on B axis
Often the correction is quite large. Such requirements are common when synchronizing cutting
knives or conveyor belts.
Synchronize two conveyor belts with trapezoidal velocity correction
:
Instruction
Interpretation
GA,A
Define A as the master axis for B.
GR,2
Set gear ratio 2:1 for B
PR,300
Specify correction distance
SP,5000
Specify correction speed
AC,100000
Specify correction acceleration
DC,100000
Specify correction deceleration
BGB
Start correction