Enable sntp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 118
Advertising
Chapter 6: Simple Network Time Protocol (SNTP) Commands
118
Section I: Basic Operations
ENABLE SNTP
Syntax
enable sntp
Parameters
None.
Description
This command is used to enable the SNTP client. When the SNTP client is
enabled, the switch or stack obtains its date and time from an SNTP
server whenever the unit is powered on or reset. To specify the IP address
of the server, refer to “ADD SNTPSERVER PEER|IPADDRESS” on
page 114. The default setting for the SNTP client is disabled.
Example
The following command enables the SNTP client:
enable sntp
AlliedWare Plus
Command
To enable the SNTP client from the AlliedWare Plus commands, refer to
the AlliedWare Plus command in “ADD SNTPSERVER
PEER|IPADDRESS” on page 114.
Command
Available
AlliedWare Plus
Advertising